((help)) jeti setup for vector thrust with powerbox srs

I have jeti ds24 and need to setup for vector thrust with powerbox royal or mercury srs

i get this from powerbox forum ..
Gyro Elevator-A for Elevator (left and right elevator- invert one side with the servo matching function)
Gyro Rudder A for the rudder

Gyro Elevator-B for vector elevator
Gyro Rudder-B for vector rudder

Following adjustments in the transmitter, you only need a 3-point switch to control everything:
Make a mixer to this switch stage 1 and stage 2 disables the vector control. Stage 3 arms the vector and makes it moving when you move elevator and rudder stick.

This switch also control the flight mode channel in the Gyro:

FM1: Gyro off
FM2: Gyro on for Aileron, Elevator and Rudder. Adjust the Gyro gain settings for this functions with the Assistant- or manually (channel by channel)
FM3: Vector gyro active: Elev-B and Rudd-B with 100% normal gain on. No heading for all axis !!

as i know until now is i have to set the elevator A to both plan elevator and set elevator B to thrust vector up & down.
also the same for rudder A for both ruder and steering and rudder B for thrust vector left and right.
this all done in powerbox .

in my jeti i set one channel for elevator and one for rudder . also set one channel for thrust vector and assign elevator stick to control it .but i thin i need to do some mixing with a switch to enable the thrust vector to work with elevator in that switch position and i couldn't do it .

my jet is a pilot PREDATOR with thrust vector?

any help pls

Hi cool_t5,
that's quite simple.
1st setup two functions vector_p and vector_r for example.
2nd assign the functions to the servo outputs you like.
3rd use the switch to bring the DualRate down to zero while you don't need vector thrust steering.

Ingmar