Start Twin Turbine

Hello everyone,

I would like to start 2 turbines separately and stop separately, what programming to do to get this?
on a ds24

Regard
Mikaël

This may work with logic switches. Which ECU do you have, or better what is the startup procedure?

Lukas

The ECU are Hornet III project, trim up and stick up 2.

Hi Mikey,

i tried to program it. I never did it before, but it seems to work

I created a Model with One Engine and two extra "Servos" (Turbine 1 and Turbine 2)
Turbine 1 is regulated by P6 with Trim on SC
Turbine 2 is regulated by P5 with Trim on SH
Now You can start, regulate and shutdown the Turbines separately.

Now I made two mixers from Throttle (the digital trim-values for the throttle I set to 0% in both directions) to Turbine 1/2, both activated by Switch SI. The Mixers with a Master Value of 75% and the standard-curve moved to 100% (in 0% / out 100%).
Now, with SI in ON You have both turbines regulated by the throttle. But as I said, it´s not perfect, because it´s a mixer. You still can regulate the turbines with P5/P6, so while flying You should not touch those and keep them in idle-position.
Look at the TEST-Model.
May be one of our Specialists can do it much better

Regards,
Volker

Thanks to you, I'm going to try Volker but I think your programming should work more simply than the Switch Logic version.

Regard
Mikaël