Mixer on Se switch DS16

Switch Se as follow :
- pos. 1 - electric motor o%
-.pos.2 - motor 40 % and a mixer with elevator - 17 %
-.pos.3 - motor 100 %
All these functions with voice announce. No problem at all.
When I try to create a new mixer for pos.3 motor 100% and elevator - 27% is not running.
I've the impression that 3 ways switch - being probably on off on type- can't be programmed with one mixer acting
only one side of the 3 ways.
I've tried also to create a flight phase "MOT100%" with elevator trim - 27% always acting via pos.3 of Se switch but
it's not running.
What can I do?
DS 16 was first time in my hands two weeks ago and starting to set up special function seems to be simply but sometimes.....impossible!
I'm sure someone had my idea to use a switch for an electric sailplane (motor use for launch or recovery at slope).
Thanks for help !
Miko

Is this the solution ?

Using Se switch create 3 different flight phases as follow :

phase 1 = pos.1 = motor o% ( let's say standard phase)

phase 2= pos.2 = motor 40% and elevator - 18% ( these values in the flight phase trimmung)

phase 3 = pos.3 = motor 100% and elevatoe - 27% ( these values in the flight trimmung)

I will think about it during my night dreams..........

Hi,

yes this works.

But remember to set from "G" (Global) to "S" so that you can make in each Flight Mode different settings via menue Flightmode trim

Have fun

Regards

PW

Perfect job !
Se is the motor stick. No changes here.
Then created 3 flight mode, standard = 0% motor, 40% motor ( and trimming -18%elevator), mot 100% ( and trimming - 35% elevator.) Flight mode also on switch Se
Perfect! coming from an old multiplex 3010 it takes time to change mental approach also due to my old age....60....
Thanks for support !

Hallo Miko,

good to hear .. as I said: have fun with Jeti TX


Regards

PW

There is another case, another sailplane.
Same set for motor, so 3 flight phase as discussed before (mot off-mot 40% -mot 100%) if you've also 3 base flight phases such as Speed,Termic and Strecke....?
means you've to create ( or copy) for each phase 3 phases for motor set
as to say :
speed phase + mot off // speed + mot 40% // speed + mot 100 %
termic + mot off / dermic + mot 40%..... and so on, ...

seems rather complicated and long.......or there is some other tricky shortcut?

thanks

Miko