problem with dual rate for for the throttle. dc-16

I can not find how to get the next throttle dual rate situation.

I like to get 0 percent power when the throttle-stick is in minimum position.
And i like to get 30 percent power when the throttle-stick is in maximum position.

I found several possibilities, but they all give the situation that the lower positions of
the throttle-stick gives no power at all.
Motor starts somewhere in the middle position of the throttle-stick....

i do use firmware version : 1.07.1

Thanks Wim

Hi Wim,

first of all I would suggest to update the TX to newest 2.22 software

To your question:

what is if you are using "function curves" and you definy the throttle switch as switch. In function curve please set "G" to "S" and if you wish you can set in "stick setup" an offset point.


regards

PW

Hi Peter,
Thanks... function curve is the key-word.... i will find my way now... i think.

i am afraid to load the new software... i made notes how to do all things... so i am afraid that my notes will be wrong after loading the
new software.....



Wim

Okay Peter,
my problem is solved now.. it works great. THANKS !
It works now like my old MX22.

i made my own user guide to remember and to install all settings...
I expect my user guide will not work perfect anymore after loading the new software 2.22.

I also wrote a lot of software to use the logging information.. when that information will change with the 2.22
i get a lot of extra work to repair it.

So Peter.. what do you think?

Hi,

I would do the update

It is winter time,so look at the release notes from Jeti what is new etc. and play a little bit.


Regards

PW

Okay Peter,
i will do.

Thanks
Wim