RSAT with MIkado VBAR Error

I am using a rsat on mikado vbar using the single line rx mode using the ppm output to the vbar.

i have noticed a few glitches while flying and in reviewing the logs on the vbar it appears there are errors occurring

below is the error message

Single Line Reciver delivers invalid input

The Pulsewidth of a Pulse in Single Line Mode is monitored. If a certain Limit is exceeded, this Error is raised. This can happen in operational mode, if the signal from the reciver is damaged or strong fields influence the slopes of the signal.

i am receiving this error with multiple models so different vbars and different rsat's ...

please help this as this is a major issue...

forgot to mention tx is dc-16

Thank you, I'll deliver the message. But for the next time, you should contact Jeti directly - for a faster solution.
And by the way - did you set these params on Rsat?
PPM output mode - I think it shoul be "direct" or try "computed" for an option.
Output period - by transmitter
Max 8 output channels.

thanks so much...

i just looked... i think it needs computed which is what its on..the reason i say this is the vbar calls for 20ms output period and if i change it to computed i lose that setting as it does not exist below computed...

vbar manual says 20ms...should it be 20ms or by transmitter and what does that actually mean??

hopefully jeti can help to identify the cause...if they need to email me they can email or contact me directly if needed

If you contact Jeti about this Problem can please write down the status here?

This week my DC-16 should arrive and i also have 2 Helis with V-Bar and Rsat2.

Do you use RSAT 1 or 2?

Regards
Boris

actually i just checked another machine , the one that had the bad glitch and it was set to direct not computed.....therefore 20ms was not an option...

i just changed it to computed with 20ms...

i hope the solution is as simple as this it needs to be computed....

can someone tell me what the default setting is on the rsat2 is it direct or computed....

i think all of my helis were in direct, i have now changed them to computed and 20ms setting...